Conveyor belt vulcanizing equipment is the special hot splicing device for conveyor belts jointing & patching, hot splicing is usually done on site by connecting the two ends of the belt. This process uses extreme heat and pressure to bond the two ends together. Once the materials have cooled down, a smooth and seamless long-lasting splice is the result.
DLCBV conveyor belt vulcanizing equipment, the main components are made of high strength aluminum alloy. It adopts the chip type electric heating element to warm up, has advantage of stable operation, high thermal efficiency and uniform temperature. It is equipped with a light automatic electric control box. The pressure system is supplied with 0-2MPa uniform pressure. It is easy to operate and portable. It is prevalent to use conveyor belt vulcanizing equipment to make joints and repair of various conveyor belts in metallurgy, mining, cement, power plants, ports, building materials, chemical industries etc.
The vulcanizing equipment is composed of the following parts.
1. Cross beam;
3. Iron plates for cushion;
7. High-pressure soft pipe;
8. Pressure-testing pump;
9. Heat-insulation plate;
10. Upper heating plates；
11. Secondary cable
12. Electric control box；
13. Primary cable;
14. Down heating plates;
15. Hydraulic plates (please find Fig1 in detail)
1. Vulcanization pressure: 1.0-2.0 MPa;
2. Vulcanization temperature: 145°C;
3. Difference in surface temperature of vulcanized plate: ± 5°C;
4. Heating up time ( at normal temperature to 145°C )<30 minutes;
5. Voltage: 220V/ 380V/415V/440V/480V/550V/660V, 50/60HZ, 3 Phases;
6. Temperature adjustment range: 0 to 199°C;
7. Timer adjustment range: 0 to 99 minutes.
1. Control the quality of the raw materials from the raw material sources;
2. During the heating sheet production process, the multimeter assists in measuring the resistance value, etc.;
3. After the sintering is finished, measure whether the temperature distribution of the heating plate is uniform, etc;
4. Measure the resistance value, and test the water pressure and machine frame before leaving the factory.
We will test our products well before exporting.
If there is nature fault of our products in One year, we will take the responsibility to change or repair new products for you.
Beyond one year, we will supply accessories (parts of vulcanizer) for our clients, and only charge the accessories fee.
If the shortages are not caused by man-made factors or faulty operation, etc, we take the responsibilities for our products within one year.