During running of conveyor, due to reasons of deviation or equipment trouble may lead to belt edge damage of both edges of conveyor belt, then we should repair it immediately. DLCBV-II belt edge repair vulcanizer is specially used to repair edge broken of conveyor belt, it suits for EP, Nylon, Canvas and steel cord conveyor belt.
DLBRV-II belt edge repair vulcanizer is specially used to repair edge broken of conveyor belt, after the conveyor stopped within a short time(usually it is 3 hours) and without dismantling the rollers, the belt edge repair vulcanizer can be used to vulcanize and repair the damaged edge effectively.
Advantages of belt repair vulcanizer
1.Aluminum Alloy material structure, light weight machine body
2.Easy to install, machine structure is simple
3.Easy to operate, adopt automatic control box
4.Uniform heating, with the aluminum alloy heating plate
5.Uniform water pressure system, with aluminum alloy material water hydraulic plate
1. Heating plate size: 320*700 mm
2. Max. Repair size: 220*600 mm
3. Working pressure: 0.5--1.0 MPa
4. Rated power: 3.6 KW
5. Heating up time< 30 minutes
6. Timer adjust range: 0-99 minutes
7. Temperature adjust range: 0-200 ℃
8. Voltage: 220-660V, 50/60HZ, 3 Phases
Belt edge repair vulcanizer
Type of conveyor belt
Canvas, nylon and steel cord belt
Maximum size for belt repairing(mm)
Heating plate size(mm)
Vulcanizing temperature 145℃
220-660V, 50/60HZ, 3 Phases
Temperature difference of vulcanized heating plates
Warm up time(min)
Installation & Usage
1. Please repair the broken place by covering with raw rubber. (See also the belt connection by vulcanization techniques in filling rubber part, or our serviceman displays the debugging of equipment.
2. Please put the down-plate, hydraulic pressure plate and down-heating plate under the broken belt place according to the structure sketch map.
3. Please put the up-heating plate, heat-insulation plate up-plate and down-plate, and keep them uniformity.
4. Please install lock shells by the same distance and tighten the screw bolts. Please connect the power and electric control box with primary conducting wire, and separately
5. Connect up-heating plate and electric control box, down-heating plate and electric control box with the Secondary conducting wire.
6. Please connect the water pump and hydraulic pressure plate with high-pressure tube, start the electric control box and fill water to the hydraulic pressure plate until the vulcanization pressure.