During running of conveyor, due to reasons of deviation or equipment trouble may lead to belt edge damage of both edges of conveyor belt, then we should repair it immediately. DLCBV-II belt edge repair vulcanizer is specially used to repair edge broken of conveyor belt, it suits for EP, Nylon, Canvas and steel cord conveyor belt.
DLBRV-II belt edge repair vulcanizer is specially used to repair edge broken of conveyor belt, after the conveyor stopped within a short time(usually it is 3 hours) and without dismantling the rollers, the belt edge repair vulcanizer can be used to vulcanize and repair the damaged edge effectively. It is an integrated equipment with multi-functionals, suits for EP, Nylon, Canvas and steel cord conveyor belt, the operation method is same as the Conveyor belt vulcanizer.
The conveyor belt edge repair vulcanizer presses are widely used in area of metallurgy, mining, power plant, ports, building materials, chemical industry etc.
1.Type of conveyor belt: Canvas, nylon and steel cord belt
2.Width rang: Any width
3.Maximum size for belt repairing: 220×600 mm
4.Heating plate size: 320×700 mm
5.Vulcanizing temperature 145℃: Adjustable 0—199℃
6.Rated power: 3.6 Kw
7.Voltage: 220-660V, 50/60HZ, 3 Phases
8.Temperature difference of vulcanized heating plate): ±3℃
9.Vulcanization pressure: 0.5-1.0 Mpa
10.Warm up time: ‹30 min
11.Timer adjust range: 0-99 minutes
1. The repairing machine should be kept in the store house under the conditions of 85 of relative humidity, and of no rain or snow.
2. During the operation or transportation, the equipment should be handled care.
3. If the interval of the operation is quite long, the insulation resistance of heating plates should be checked before operating the vulcanizer.
4. The working pressure should not be exceeded 0.8Mpa. It is necessary to pay attention to the working pressure required when filling with water to raise the pressure.
5. Ask the electrician to check and repair if there is anything wrong with the control panel.
6. If the product does have any problem of manufacturing quality in 12 months from purchasing, we will maintain for the user or displace the parts free of charge.